"Universal" Coolidge X-ray Tube

Paul Frame, Oak Ridge Associated Universities

The Universal Tube was so named because it could be used in almost any application, e.g., diagnostic x-rays (roentenography), fluoroscopy and therapy as well as various non-medical uses.  In essence, it is the original Coolidge tube with a few minor modifications. 

During operation, the heat from the anode is radiated out through the bulb of the tube.  So that the glass won’t overheat, the bulb has to be kept fairly large: ca.  6 – 7” in diameter.

The threaded screw-in connector at the end of the cathode arm is the same as that employed with a light bulb.  This reflects the fact that William Coolidge’s inspiration for the hot cathode x-ray tube was his earlier work developing tungsten filaments for incandescent lights.

The anode is solid tungsten and it is attached to a molybdenum stem. The latter, in turn, is connected to a split metal tube that helps provide support.  

There were three variations on the Universal tube: those with a fine focal spot, those with a medium focal spot, and those with a broad focal spot. The cathode filament of the fine focus version forms a flat spiral near the end of a short molybdenum tube, while that of the medium and broad focal spot tubes forms a slightly conical spiral. 

The following table indicates the ratings for these tubes.

Tube Type

Maximum Voltage

Equivalent Spark Gap

Maximum Current

Continuous use limit

Fine Focus

100,000

6”

25 mA

20 seconds

Medium Focus

100,000

6”

40 mA

15 seconds

Broad Focus

100,000

6”

80 mA

5 seconds

Broad Focus

140,000

10”

5 mA

continuous

The fine and medium focus tubes were better for general radiographic work. The broad focus Universal tube was best suited for therapeutic use because of its greater potential output. When the broad focus tube was operated at very high voltages, it would have been particularly important to keep the tube clean and far enough away from metal objects to prevent sparking.

The Universal tube needed to be operated with a rectified current. If unrectified AC current were used, electron emission from the tungsten target would be possible during the half of the cycle when the target ("anode") had a negative charge and the “cathode” a positive charge. This could only occur if the target had been heated to the point that it emitted electrons.  

References

E. C. Jerman. Modern X-Ray technic. Bruce Publishing Co. St. Paul. 1928.

Radiology – An Illustrated History.

W.D. Coolidge. The development of modern roentgen-ray generating apparatus. Am. J. Roentgenology. 24: 605-620. 1930.

M.J. Gross, Z.J. Atlee. Progress in the design and manufacture of x-ray tubes. Radiology  :365-377; 1933.

Coolidge Type X-Ray Tubes               Museum Directory

Last updated: 06/24/09
Copyright 1999, Oak Ridge Associated Universities